How to Clean and Maintain Exhaust Spot Lights in Stone Finish

Quick answer

Clean your Exhaust Spot light in Stone finish with a soft, dry microfiber cloth to remove dust. For deeper cleaning, use a barely damp cloth with mild soap, then dry immediately to protect the powder-coated metal and solid metal detailing.

Step-by-step cleaning process

1. Turn off and cool down: Switch off the light at the wall and wait until the bulb and metal body are completely cool. A hot fixture can cause cleaning solutions to evaporate too quickly or leave residue. Always work with a cool, unpowered fixture for safety and best results.
2. Dry dust the exterior: Use a soft, dry microfiber cloth to gently wipe the powder-coated body, the cross-knurl baffle, and the coin screws. Work from top to bottom so dust falls away from cleaned areas. Avoid pressing hard on the baffle — it is meant to capture light, not force. Common mistake: using a feather duster can push dust into the baffle grooves. A microfiber cloth lifts dust without redistributing it.
3. Clean the baffle and filter area: For the honeycomb filter and cross-knurl baffle, use a clean, dry paintbrush or a soft toothbrush to dislodge dust from the crevices. Hold the fixture steady with one hand and brush gently with the other. Do not remove the baffle — it is not designed for user disassembly. Checkpoint: if dust is stubborn, a compressed air duster (canned air) can be used from a distance of 6 inches. Never use a vacuum attachment directly on the baffle.
4. Damp clean only when needed: Dampen a microfiber cloth with water and a drop of mild dish soap. Wring it until barely moist — no dripping. Wipe the powder-coated surfaces gently, then immediately follow with a dry microfiber cloth to remove any moisture. Keep liquid away from the GU10 socket and the honeycomb filter. Common mistake: leaving moisture on the Stone finish can create water spots or dull the matte texture. Dry immediately.
5. Polish the metal details: For the machined coin screws and any exposed solid metal accents, use a dry microfiber cloth to buff them lightly. This restores their subtle sheen without adding any polish or wax. The powder-coated body should remain matte — do not buff the main surface. Skip metal polishes — they are not needed and can leave residue on the powder coating.
6. Inspect and reassemble: Once the fixture is completely dry, check that the GU10 bulb is seated securely and the honeycomb filter is aligned. Turn the power back on and test the light. If the beam appears uneven, the filter may need gentle repositioning with a dry cloth. Checkpoint: an uneven beam usually means the filter shifted during cleaning. Gently nudge it back into place with a dry cloth.

Product facts

• EXHAUST SPOT / CROSS / STONE: The Exhaust Spot / Cross / Stone has a powder coated metal body and solid metal detailing, including a signature cross-knurl baffle and machined coin screws. The powder coating is durable but sensitive to abrasive cleaners, so a soft cloth and mild soap are essential to avoid damaging the finish.