How to Install a 1G Toggle 2-Way Linear Switch

By Home Fashion Label - Extraordinary Products - Buster + Punch | Published: 2026-10-26

Category: How-to Guides

Step-by-step guide to installing a Buster + Punch 1G toggle 2-way linear switch. Learn wiring, safety tips, and common mistakes to avoid.

Quick answer

Turn off power at the breaker, identify your two-way wiring, connect the live and traveler wires to the Buster + Punch 1G toggle switch terminals, and secure the module and plate. Always double-check polarity before restoring power.

Understanding 2-way switching with a 1G toggle

A 2-way switch lets you control one light from two locations, such as the top and bottom of stairs. The Buster + Punch 1G toggle switch is designed for this setup when paired with another compatible switch at the second location.

The solid metal construction and linear knurled toggle arm give a premium feel, but the wiring follows standard 2-way principles. Make sure you have the correct module orientation before mounting.

Tools and safety prep

You will need a voltage tester, screwdrivers (flathead and Phillips), wire strippers, and the Buster + Punch 1G toggle switch kit. Always use a voltage tester to confirm the circuit is dead before touching any wires.

If you are replacing an existing switch, take a photo of the old wiring for reference. This avoids confusion with common (COM), L1, and L2 terminals.

Installation steps

Turn off power and verify: Switch off the circuit breaker controlling the switch. Use a voltage tester to confirm no power is present at the existing switch box. Never skip the voltage test – even if the breaker is off, residual charge can exist.
Remove the old switch and identify wires: Unscrew and pull out the existing switch. Identify the common (COM) wire (usually black or red) and the two traveler wires (often the same color). Label them with tape to avoid confusion. If you cannot identify the common wire, check the old switch markings or consult a wiring diagram for your setup.
Connect wires to the Buster + Punch switch: Connect the common wire to the COM terminal on the toggle module. Connect the two traveler wires to the L1 and L2 terminals. Tighten each screw securely. A loose connection can cause intermittent operation or arcing. Give each screw a firm tug after tightening.
Mount the module and attach the plate: Gently push the wired module back into the wall box, ensuring wires are not pinched. Align the metal plate and secure it with the provided screws. Attach the linear knurled toggle arm and torx caps as per the kit instructions. Over-tightening the plate screws can warp the metal. Snug is sufficient.
Test the switch before finalizing: Restore power at the breaker. Test the switch from both locations to confirm the light turns on and off correctly. If it does not work, turn off power again and re-check your wiring. If the switch works in one position but not the other, you likely swapped the traveler wires. Swap them and test again.

Product spotlight

1G TOGGLE / 2-WAY / LINEAR / STEEL: The 1G toggle switch is made from solid metal with a steel finish and features a brushed solid metal plate, toggle module, and a detail kit with a signature linear knurled toggle arm. The solid metal build ensures durability and a premium feel, while the linear knurled toggle arm provides a distinct tactile operation that stands out from standard plastic switches.
1G TOGGLE / 2-WAY / LINEAR / STEEL