How to Install a 2G Wall Plate for Dimmers or Toggles

Quick answer

Installing a 2G wall plate for dimmers or toggles is a straightforward process: align the plate over the two modules, secure it with screws, and attach the detail kits for a finished look. The key is to ensure the plate sits flush and the screws are not overtightened.

Step-by-Step Installation Guide

1. 1. Turn Off Power: Switch off the circuit breaker for the wall box you are working on. Use a voltage tester to confirm no power is present. This is a critical safety step before handling any wiring or mounting. Always double-check with a tester; never assume the power is off.
2. 2. Mount the Modules: Install your two dimmers or toggles into the wall box according to the manufacturer's instructions. Ensure they are aligned evenly and the mounting screws are snug but not overtightened. The modules should sit flush with the wall surface. If one module is recessed, the plate will not sit flat. Use a level to check alignment.
3. 3. Position the 2G Wall Plate: Place the 2G wall plate over the two modules, aligning the screw holes with the module's threaded inserts. The plate should sit evenly without gaps. If it rocks, check module alignment. A rocking plate usually means one module is not flush. Adjust before tightening.
4. 4. Secure the Plate with Screws: Insert the provided screws and tighten them alternately (a few turns on each) to keep the plate balanced. Stop when the plate is snug against the wall. Do not overtighten, as this can dent the metal or crack the drywall. Use a hand screwdriver, not a power drill, to avoid overtightening.
5. 5. Attach the Detail Kits: If using Buster + Punch detail kits, snap or screw them onto the module stems according to the kit instructions. Ensure they are fully seated and aligned with the plate openings. Check that the knurl pattern matches your desired orientation before finalizing.
6. 6. Restore Power and Test: Turn the circuit breaker back on. Test each dimmer or toggle to ensure it operates correctly. If a switch feels stiff or does not function, re-check the detail kit installation. If a dimmer buzzes or a toggle sticks, the plate may be pressing on the module. Loosen the screws slightly.

Product Facts

• 2G WALL PLATE / FOR 2 DIMMERS OR TOGGLES: A modular 2G wall plate made from solid metal and available in a range of Buster + Punch finishes. Pair with two modules (dimmers, toggles or a combination of both), then finish with our signature detail kits in the knurl and finish of your choice. This means you can customize the look of your switch plate to match your interior, and the modular design makes future upgrades easier.