How to Install a 4G Toggle 2-Way Cross Switch

Quick answer

Install a 4G toggle 2-way cross switch by first turning off power, then wiring each toggle module as a 2-way or intermediate switch, and finally securing the plate. Always double-check your wiring before restoring power.

Step-by-Step Installation Process

1. Turn Off Power and Verify: Switch off the circuit breaker for the switch box. Use a voltage tester to check that all wires in the box are dead. This is critical for safety. Common mistake: forgetting to test all wires, especially if the box contains multiple circuits. Always test each wire individually.
2. Remove the Old Switch (if applicable): Unscrew the old switch plate and disconnect the wires. Note which wires are line (power in), load (to the light), and travelers (between switches). Label them with tape for clarity. If you're installing in a new box, skip this step. For retrofits, take a photo of the old wiring before disconnecting.
3. Prepare the 4G Toggle Switch: Remove the plate from the switch unit by unscrewing the coin screws. The toggle modules are pre-installed but can be swapped if needed. For a 2-way setup, each module needs two traveler wires and one common wire. The modules are independent; you can wire each one separately. Do not assume all modules share a common wire.
4. Wire the First Toggle Module: Connect the common wire (usually black) from the light or power source to the common terminal on the module. Connect the two traveler wires (often red and black) to the traveler terminals. Tighten screws securely. Common mistake: mixing up common and traveler wires. The common terminal is usually marked 'COM' or has a different color screw. If unsure, check the module's documentation.
5. Wire the Remaining Three Modules: Repeat the wiring process for each of the other three toggle modules. Each module controls its own light or device. Ensure no wires are touching between modules to avoid shorts. If you have a multi-gang box, the wires for each module may be in separate cables. Keep them organized to avoid confusion.
6. Secure the Switch Plate: Gently push the wired modules back into the wall box, ensuring wires are not pinched. Align the plate with the mounting holes and screw it in place using the provided coin screws. Do not overtighten. Overtightening can crack the plate or strip the screws. Snug is sufficient.
7. Restore Power and Test: Turn the circuit breaker back on. Test each toggle module by flipping it up and down. The light should turn on and off from both switch locations if wired correctly. If a module doesn't work, turn off power and check the wiring for that module. A loose traveler wire is a common issue.

Product Details

• 4G TOGGLE / 2-WAY / CROSS / SMOKED BRONZE: A 2G quadruple toggle switch made from solid metal with a smoked bronze finish. It features a brushed solid metal plate, four toggle modules and a detail kit with our signature cross-knurled toggle arms, solid metal toggle nuts and coin screws. The solid metal construction and modular design mean you can install it once and later swap modules for different functions or finishes without replacing the entire plate.